Irritrol RainSensor Manual do Utilizador

IntroductionCongratulations on your purchase of the Irritrol Wireless RainSensor. The WirelessRainSensor components are designed for easy installation

Sensor/Transmitter Battery Replacement1. Remove the bottom cover of the Sensor/Transmitter by pressing down on thethumb-release lever on the side of t

TroubleshootingSignal Indicator (Installation ValidationTM)The Signal Indicator provides instant signal strength feedback for the installer. The indic

Specifications:Model Numbers: RS1000 - Wireless RainSensorRFS1000 - Wireless RainSensor + FreezeReceiver Mounting Options: Stainless steel screws and/

Component OverviewReceiver (Figure 1)1 - Weather-resistant Cover:Slides upward to remove. Protectsthe receiver module when locatedoutdoors. Keep the c

Quick Start Installation InstructionsThe following instructions are provided for the experienced installer. Refer to Figures 3–5 below. Note: When ins

Detailed Installation InstructionsThere are two main components of the Wireless RainSensor: the Receiver and theSensor/Transmitter. The Receiver is in

B. Controllers with no sensor inputs and no pump start or master valve:Refer to Figure 7. Disconnect the valve common wire from the controller’s commo

Part 2 - Power Wire ConnectionNote: The Receiver requires a nominal voltage of 24 VAC to operate. It should onlybe connected to an irrigation controll

Rainfall AdjustmentThe Sensor/Transmitter can be adjusted torespond when it has detected nominal rainfall inthe following amounts: 1/8" (3mm), 1/

InstallationThe Sensor/Transmitter should be mounted vertically with the antenna wire extendingstraight down. Avoid installations where theantenna wir

Wireless RainSensor OperationNormal OperationWhen the Wireless RainSensor activates due to sufficient rainfall or freezing tempera-tures (model RFS100